NVR/Basic Setup/Set IP Address

Revision as of 20:56, 4 December 2015 by Qi (talk | contribs) (How to set IP address for configuring IP cameras)

How to set IP address for configuring IP cameras

Connect a RJ45 cable from camera to NVRThen connect a RJ45 cable from NVR to PC.

Go to wifi to be on the same network as the camera.


Go and find the IP address of the camera using the config tool.

Set the IP address of the laptop same as the camera.

Here's how: Open up network and sharing center

Step 1: Click on adapter settings

IPCSetIP1.jpg

Step 2: Click on Ethernet

IPCSetIP2.jpg

Step 3: Internet Protocol version 4

IPCSetIP3.jpg

Step 4: Properties

File:IPCSetIP4.jpg

Step 5: Make sure you put it on use the following IP address!

File:IPCSetIP5.jpg

Then you can proceed to configure the camera such as an firmware upgrade.