NVR/Basic Setup/Set IP Address

How to set IP address for configuring IP cameras

Connect a RJ45 cable from camera to NVRThen connect a RJ45 cable from NVR to PC.

Go to wifi to be on the same network as the camera.

Go and find the IP address of the camera using the config tool.

Set the IP address of the laptop same as the camera.

Here's how: Open up network and sharing center Step 1: Click on adapter settings File:IPCSetIP1.png Step 2: Click on Ethernet File:IPCSetIP2.png Step 3: Internet Protocol version 4 File:IPCSetIP3.png Step 4: Properties Step 5: Make sure you put it on use the following IP address! Then you can proceed to configure the camera such as an firmware upgrade.