Difference between revisions of "NVR/Basic Setup/Set IP Address"
(→How to set IP address for configuring IP cameras) |
(→How to set IP address for configuring IP cameras) |
||
| Line 11: | Line 11: | ||
Here's how: | Here's how: | ||
Open up network and sharing center | Open up network and sharing center | ||
| + | |||
Step 1: Click on adapter settings | Step 1: Click on adapter settings | ||
[[File:IPCSetIP1.png]] | [[File:IPCSetIP1.png]] | ||
| + | |||
Step 2: Click on Ethernet | Step 2: Click on Ethernet | ||
[[File:IPCSetIP2.png]] | [[File:IPCSetIP2.png]] | ||
| + | |||
Step 3: Internet Protocol version 4 | Step 3: Internet Protocol version 4 | ||
[[File:IPCSetIP3.png]] | [[File:IPCSetIP3.png]] | ||
| + | |||
Step 4: Properties | Step 4: Properties | ||
[[File:IPCSetIP4.png]] | [[File:IPCSetIP4.png]] | ||
| + | |||
Step 5: Make sure you put it on use the following IP address! | Step 5: Make sure you put it on use the following IP address! | ||
[[File:IPCSetIP5.png]] | [[File:IPCSetIP5.png]] | ||
| + | |||
Then you can proceed to configure the camera such as an firmware upgrade. | Then you can proceed to configure the camera such as an firmware upgrade. | ||
Revision as of 20:46, 4 December 2015
How to set IP address for configuring IP cameras
Connect a RJ45 cable from camera to NVRThen connect a RJ45 cable from NVR to PC.
Go to wifi to be on the same network as the camera.
Go and find the IP address of the camera using the config tool.
Set the IP address of the laptop same as the camera.
Here's how: Open up network and sharing center
Step 1: Click on adapter settings File:IPCSetIP1.png
Step 2: Click on Ethernet File:IPCSetIP2.png
Step 3: Internet Protocol version 4 File:IPCSetIP3.png
Step 4: Properties
Step 5: Make sure you put it on use the following IP address!
Then you can proceed to configure the camera such as an firmware upgrade.
