Difference between revisions of "3rd Party VMS/Control4/Setup Video Feeds"
(→Step by Step Instructions to Use Main Stream) |
|||
| Line 12: | Line 12: | ||
*Choose Proper Channel (repeat for each channel) | *Choose Proper Channel (repeat for each channel) | ||
*Change Main Stream Settings to the following (note: these settings are best practices; individual systems may require modification of these settings for certain applications) | *Change Main Stream Settings to the following (note: these settings are best practices; individual systems may require modification of these settings for certain applications) | ||
| + | |||
| + | [[File:Control_4_How_To_Use_Main_Stream_1.jpg|600px]] | ||
1. Code-Stream Type: Continuous | 1. Code-Stream Type: Continuous | ||
| Line 26: | Line 28: | ||
IF MJPEG is required do the following: | IF MJPEG is required do the following: | ||
| + | |||
| + | [[File:Control_4_How_To_Use_Main_Stream_2.jpg|600px]] | ||
1. Enable Sub Stream on Channel | 1. Enable Sub Stream on Channel | ||
| Line 36: | Line 40: | ||
5. Bit Rate: 1024 | 5. Bit Rate: 1024 | ||
| + | |||
==Step by Step Instructions to Use Sub Stream== | ==Step by Step Instructions to Use Sub Stream== | ||
Revision as of 17:43, 30 April 2019
Contents
How to Setup Video Feeds on Dahua IP Camera or Recorder
Description
This article will show you how to configure a video stream from a Dahua device for integration with Control 4
Prerequisites
Video Instructions
Step by Step Instructions to Use Main Stream
Note: Certain older Control4 equipment require MJPEG for video stream (HC800, HC250, Infinity Touchscreens etc..). If these older devices are used at property, the dealer MUST enable Sub Stream and set to MJPEG. If dealer is using T3 and EA controllers, MJPEG does not need to be used
- Log into NVR or use GUI and go to Setup
- Select IMAGE, ENCODE
- Choose Proper Channel (repeat for each channel)
- Change Main Stream Settings to the following (note: these settings are best practices; individual systems may require modification of these settings for certain applications)
1. Code-Stream Type: Continuous
2. Compression: H.264
3. Resolution: 1280*720(720P)
4. Frame Rate(FPS): 13
5. Bit Rate Type: VBR
6. Bit Rate: 1024
IF MJPEG is required do the following:
1. Enable Sub Stream on Channel
2. Compression: MJPEG
3. Resolution: 704*480(D1)
4. Frame Rate(FPS): 13
5. Bit Rate: 1024
