Difference between revisions of "Cyber Security/VPN Setup"
(→Step by Step Instructions) |
(→Prerequisites) |
||
| Line 9: | Line 9: | ||
*Router running DD-WRT with VPN Capabilities | *Router running DD-WRT with VPN Capabilities | ||
*DVR, NVR, or IP Camera connected to network with DD-WRT router | *DVR, NVR, or IP Camera connected to network with DD-WRT router | ||
| + | *WAN IP of VPN Host-This can be identified by going to [www.CanYouSeeMe.org] | ||
===Video Instructions=== | ===Video Instructions=== | ||
Revision as of 19:23, 28 October 2016
Contents
How to Setup a VPN using DD-WRT Router
Definition
A VPN (Virtual Private Network) is a virtual encrypted tunnel through an network (e.g. the internet) to connect a client (or whole network) to a server (or network). This allows you to not only use local network resources, such as printers or file servers, from anywhere you have an internet connection but also gives you a safe tunnel to browse the web through. Using a VPN you can browse web sites from a free access point at a hotel without worrying about others seeing your data. This is also a common way to bypass web content filters. -DD-WRT Wiki
Description
The below instructions will show you how to setup a VPN using a DD-WRT router. This will allow you to remotely access the network your security device is on.
Prerequisites
- Two networks. One local, and one remote
- Router running DD-WRT with VPN Capabilities
- DVR, NVR, or IP Camera connected to network with DD-WRT router
- WAN IP of VPN Host-This can be identified by going to [www.CanYouSeeMe.org]
Video Instructions
Step by Step Instructions
DD-WRT Setup
1. Login to your DD-WRT by entering the gateway address into your web browser.
2. Click, "Services"
3. Then click, "VPN"
4. Your settings should look like the following: PPTP Server: Enabled Broadcast Support: Enabled MPPE Encryption: Enable DNS1: Your Modem's DNS1 DNS2: 8.8.8.8 WINS1: (Leave Blank) WINS2: (Leave Blank) MTU: (Leave Defaults) MRU: (Leave Defaults) Server IP: (IP Address in Upper Right Corner of WW-WRT Interface. Example: 192.168.0.2) Client IP(s): (IP Range within DD-WRT's DHCP Range. Example: 192.168.1.150-160) Max Associated Clients: (Leave Defaults) Authentication: Local User Management (CHAP Secrets) CHAP-Secrets: username * YOURPASSWORD * (Must be all lowercase, and must follow this syntax.) Example: myusername * myvpnpassword *
5. Ensure all other options are disabled.
6. Click, "Save" at the bottom of the page.
7. Click, "Apply Settings"
