Difference between revisions of "Troubleshoot/NVR/Motion Record Troubleshoot"
(→Motion detection function does not work.) |
(→Motion detection function does not work.) |
||
| Line 11: | Line 11: | ||
[[File:motiontrouble8.png|500px]] | [[File:motiontrouble8.png|500px]] | ||
| − | [[File:motiontrouble112.png| | + | [[File:motiontrouble112.png|445px]] |
[[File:motiontrouble9.png|500px]] | [[File:motiontrouble9.png|500px]] | ||
Revision as of 15:15, 6 May 2016
Motion detection function does not work.
There are following possibilities:
- Sensitivity is too low.
- Most third-party cameras will not have the full capabilities, like motion detection, to work.
- Check if firmware of Recorder and IP camera is current.
- Ensure motion detect set on the correct cameras.
- Period setup is not correct.
- Motion detection zone setup is not correct.
- Try defaulting camera settings.
- Ensure enable and record is checked off and saved.
- Ensure Working Period is set up and settings are saved
- Ensure the schedule is set for motion recording.
