Difference between revisions of "Troubleshoot/NVR/Motion Record Troubleshoot"
(→Motion detection function does not work.) |
(→Motion detection function does not work.) |
||
| Line 9: | Line 9: | ||
* Default camera settings. | * Default camera settings. | ||
* Ensure motion detect set on the correct cameras. | * Ensure motion detect set on the correct cameras. | ||
| + | * Ensure enable and record is checked off. | ||
| + | |||
| + | [[File:motiontrouble1.png|500px]] | ||
[[Category:Record]] | [[Category:Record]] | ||
[[Category:Troubleshoot]] | [[Category:Troubleshoot]] | ||
Revision as of 15:12, 3 May 2016
Motion detection function does not work.
There are following possibilities:
- Period setup is not correct.
- Motion detection zone setup is not correct.
- Sensitivity is too low.
- Most third-party cameras will not have the full capabilities, like motion detection, to work.
- Check firmware.
- Default camera settings.
- Ensure motion detect set on the correct cameras.
- Ensure enable and record is checked off.
