Difference between revisions of "Troubleshoot/NVR/Motion Record Troubleshoot"
(→Motion detection function does not work.) |
(→Motion detection function does not work.) |
||
| Line 11: | Line 11: | ||
* Sensitivity is too low. | * Sensitivity is too low. | ||
* Most third-party cameras will not have the full capabilities, like motion detection, to work. | * Most third-party cameras will not have the full capabilities, like motion detection, to work. | ||
| − | * Check firmware. | + | * Check if firmware of Recorder and IP camera is current. |
* Default camera settings. | * Default camera settings. | ||
Revision as of 18:12, 4 May 2016
Motion detection function does not work.
There are following possibilities:
- Period setup is not correct.
- Motion detection zone setup is not correct.
- Sensitivity is too low.
- Most third-party cameras will not have the full capabilities, like motion detection, to work.
- Check if firmware of Recorder and IP camera is current.
- Default camera settings.
- Ensure motion detect set on the correct cameras.
- Ensure enable and record is checked off.
- Ensure Working Period is set up and settings are saved
